Leading Edge
The Raptor
T-Clamp
A module-bonding clamp built around an asymmetrical design — torque down one module before you set the next, with a tight 1/4" reveal between panels for a clean finished line.
Sequential Install
Tighten as
You Go.
The asymmetrical jaw means each clamp locks down fully before the next module goes in — no coming back to re-torque a shared clamp after the array is laid out. It's one motion per module, in the order you're already working.
- Module-to-module bonding
- Asymmetrical clamp design
- Sequential module install
- Tight 1/4" module spacing
- Single-tool installation
- Low-profile, clean finish
Bonding Architecture
No Copper Jumpers Required.
The Raptor T-Clamp is built on a UL 2703-listed bonding architecture documented by our manufacturing partner — module-to-module bonding through the clamp itself means no separate copper grounding jumpers to run and land at every panel.
Full UL 2703 bonding documentation is in the Technical Resource Center, issued to the underlying manufacturer of record. See the sourcing notice there for details.